WERTHER INTERNATIONAL J1P Manuel D'instructions page 9

FAILURE TO COMPLY WITH THESE REGULATIONS CAN CAUSE SERIOUS INJURY TO
PERSONS, AND TO THE VEHICLE BEING LIFTED.
It is necessary that the jack and the vehicle are on the same plane. Furthermore the surface
where the jack is installed has to be levelled out.
NO!
OK
I CAUTION
ATTENTION : J2P AND J3P ARE NOT LIFTS, FOR THIS REASON IT IS FORBIDDEN ANY
USE WHICH DIFFERS FROM THE ONE PROJECTED FOR THESE EQUIPMENTS.
DO NOT WAIT UNDER THE RAISED VEHICLE.
USE
Connect the jack to a compressor able to reach at 2
least 7 bar pressure and connected to the proper
plug (1) on the left side of the distributor attached
to the jack handle.
Position the jack under the vehicle to lift and press
the left button
3
(2 - ascent) of the distributor box.
1
Once the repairing operations on the vehicle have
been finished, press the right button (3 - descent)
to lower the vehicle.
9