Maintenance And Cleaning - IKEA FIXA Traduction Des Instructions Originales

8
Vertical Alignment (see figure B):
Position the laser spirit level with the
two supporting points (6) against the
wall with the help of pins (not included)
or on a magnet surface with the help
of the magnets (11). The exit opening
for the laser beam (4) must face
downward. Align the laser spirit level
vertically with help of the spirit level
(3). Top and bottom cabinets, as an
example, can be aligned alongside the
vertical laser line.
Alignment of 45 degree (see figure
C): Position the laser spirit level with
the two supporting points (6) against
the wall with the help of pins (not
included) or on a magnet surface with
the help of the magnets (11). Align the
laser spirit level horizontally with help of
the spirit level (5).
Checking Horizontal/Vertical Lines
with the Spirit Levels without laser
beam
The laser spirit level can be used as a
contractors level for checking horizontal
or vertical lines, e.g., for the level set-
up of a washer or a refrigerator. Position
the laser spirit level with the aluminium
supporting surface (2) facing against
the surface to be checked. When
positioning against horizontal surfaces,
the aluminium supporting surface (2)
must face downward. When positioning
against vertical surfaces, the exit
opening for the laser beam (4) must
face downward.

MAINTENANCE AND CLEANING

Check the laser spirit level before
each time you use it. In case of
visible damage or loose components in
the interior of the laser spirit level,
the safe function is no longer ensured.
Keep the laser spirit level clean and dry
at all times to ensure proper and safe
operation.
Wipe off any debris using a soft cloth,
moistened with water. Do not use any
cleaning agents or solvents.