Measuring Functions - IKEA FIXA Traduction Des Instructions Originales

line with a known horizontal or
vertical reference line.
Switching On and Off
To switch on the laser spirit level, push
the On/Off switch (7). Immediately
after switching on, the laser spirit level
sends a laser beam out of the exit
opening (4).
• Do not point the laser beam at
persons or animals and do not
look into the laser beam yourself,
not even from a large distance.
To switch off the laser spirit level, push
the On/Off switch (7) again.
• Do not leave the switched on
laser spirit level unattended and
switch the laser spirit level off
after use. Other persons could be
blinded by the laser beam.

MEASURING FUNCTIONS

Note: The specified levelling accuracy
applies for the alignment of the laser
beam with reference to the spirit levels
(1), (3) and (5).
Positioning the laser spirit level
For precise alignment with the spirit
levels, the position of the laser spirit
level is important.
The specified levelling accuracy is only
achieved when the laser spirit level is
correctly positioned:
• For horizontal alignment with the
spirit level (1), the aluminium
supporting surface (2) of the laser
spirit level must face downward.
• For vertical alignment with the spirit
level (3), the exit opening for the
laser beam (4) must face downward.
Aligning with the Laser Line
Horizontal Alignment (see figure A):
Position the laser spirit level with the
two supporting points (6) against the
wall with the help of pins (not included)
or on a magnet surface with the help
of the magnets (11). The aluminium
supporting surface (2) of the laser spirit
level must face downward. Align the
laser spirit level horizontally with help
of the spirit level (1). Picture frames
or tiles, as an example, can be aligned
alongside the horizontal laser line.
7