Crouzet CTR24L-2511 Notice De Mise En Service page 10

3. Programming routine
The first menu item is the selection of the basic
operating mode, which determines the functions
of the device.
Pulse counter/Position indicator
(Operating mode pulse counter)
1. Description
• 6-digit display counter with SET/RESET-function
• Red LED display, character height 8 mm
• Display range from -199 999 to 999 999
• Leading zeros suppression
• Programming via two setting keys on the front
side
• During programming, the display guides the
user with text prompts
• Counter operating modes:
Count input INP A + count direction input
INP B (Cnt.Dir)
Differential count INP A – INP B (up.dn)
Totalising INP A + INP B (up.up)
Count Up/Down INP A 90° INP B x 1 (quAd)
Count Up/Down INP A 90° INP B x 2 (quAd 2)
Count Up/Down INP A 90° INP B x 4 (quAd 4)
2. Inputs
INP A
Dynamic count input.
INP B
Dynamic count input.
SET/RESET
Dynamic SET/RESET input. Linked in parallel to
the red SET/RESET key. Resets the counter to
the predefined setting value.
Operating mode pulse
counter. Continued in point
3. on page 2
Operating mode frequency
meter. Continued in point 3.
on page 4
Operating mode time meter.
Continued in point 3. on
page 6
3. Programming routine
The programmable parameters of the device are
described below, in the order in which they can
be set. The device is fully programmed after one
pass of the routine.
The first values stated correspond to the factory
settings
3.1 Polarity of the inputs
3.2 Switching on the 30 Hz filter (INP A, INP B)
3.3 Input mode
* where bounce occurs, e.g. with contacts
npn: switching for 0 V
pnp: switching for +U B
The filter provides input
damping*
30 Hz filter off (f max )
30 Hzfilter on
Count input and count
direction input
INP A: Count input
INP B: Count direction
input
Differential input
IINP A: count input adding
INP B: count input
subtracting
Totalising
INP A: count input adding
INP B: count input adding