Southwire QWIKjax Instructions D'utilisation Et D'entretien page 7

OPERATION
1. Two QWIKjax™ Reel
Stands and one Southwire
Axle are required for a
complete setup.
(The QJ-01 reel stands must be
used with only the PJA-01
or PJA-02 axles).
2. Make sure the cable reel
is chocked to prevent
movement during setup.
3. Position the axle through
the center holes of the cable
reel.
4. Position QWIKjax™ Reel
Stands under each end of
the axle so the reel stand
rollers are aligned within
and in contact with the axle
grooves (Fig. 5).
5. Ensure one QWIKjax™ is
under each end of the axel
Note: The QWIKjax™ Reel Stands may require use of the
QWIKjax™ fast adjust feature. Remove the roller cradle lock pin (3)
on back of the roller cradle (2) and manually slide roller cradle (2)
up or down to desired height (Fig. 6 and 7). Use the roller cradle
lock pin (3) provided by inserting through both sides of the back
plate. The roller cradle pin (3) must rest on top of the pin support
bar to prevent downward movement. Insert supplied cotter key
back into pin.
6
Fig. 5