Disconnecting The Water Supply Hose / Positioning The Drain Hose - Avanti CTW84X0W-IS Manuel D'instructions

DISCONNECTING THE WATER SUPPLY HOSE
Dismantling the hose directly may cause water to splash due to the possible high water pressure in
the hose, even after the faucet has been turned off. Please take off the hose as per following steps,
even if the faucet is closed:
·
Turn off the faucet.
·
Turn on the power and let the machine run for about 5 seconds then turn
it off.
·
Remove the connecting nuts from the faucet and washing machine.
Note: If the washing machine is frequently used, it is not necessary to dismantle
the inlet hose to avoid possible damage to the threads.
POSITIONING THE DRAIN HOSE
Since only up drainage is available, drain hose can be hung in the basin or
bathtub.
NOTE: The highest point of the drain hose must be in the height of 2.5 –
3.25 feet above floor level, otherwise, the washer cannot work normally.
11
CONNECTING
NUT