Installation Instructions; Before Using Your Portable Washer; Selecting A Location / Moving Your Washer / Installing The Inner Safety Lid - Avanti CTW84X0W-IS Manuel D'instructions

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

BEFORE USING YOUR PORTABLE WASHER

Remove the exterior and interior packing.

You will need the following tools:

Wrench

Pliers

Screwdriver

Check to be sure you have all of the following parts:

1 Inlet Hose

1 Faucet Adapter

1 Drain Hose Assembly

Remove shipping brace. Note - It should be saved and used (to prevent damage to washer

components) whenever washer is moved or transported to a new location.

Clean the interior surface with lukewarm water using a soft cloth.

Allow 2 inches of space between the back and sides of the appliance.

Put your laundry into the washer evenly. Uneven laundry may cause noise or vibration.

DO NOT use excessively hot water (122ºF / 50°C or more). Plastic parts may be deformed or

damaged. Also, clothing may be deformed or bleached.

Before washing, check all pockets. If nails or pins remain in pockets, they may damage the

washer or clothes.

Never splash water on the control panel.

Plug the washer into an exclusive properly installed-grounded wall outlet. Do not under any

circumstances cut or remove the third (ground) prong from the power cord. Any questions

concerning power and/or grounding should be directed toward a certified electrician or an

Authorized Avanti Products service center.

SELECTING A LOCATION

Before you install the portable washer, select a location with the following

characteristics:

A hard level surface (if the surface is uneven, see Adjusting The

Adjustable Foot section on the next page).

Away from direct sunlight. Direct sunlight may affect the acrylic coating,

plastic and electrical components.

Adequate ventilation.

Away from sources of heat such as coal or gas. Make sure that the

washing machine does not stand on its power cord.

Ventilation openings must not be obstructed by carpeting when the

portable washer is installed on a carpeted floor.

It is recommended that you place your portable washer on a hard material

floor such as tile, concrete, linoleum and to avoid if at all possible

placement on wooden floors or carpeted areas.

MOVING YOUR WASHER

To move your washer, tilt the unit back onto its rear

rollers and push it forward as shown in the figure.