Connecting The Water Supply Hose / Sink Faucet Connection - Avanti CTW84X0W-IS Manuel D'instructions

CONNECTING THE COLD WATER SUPPLY HOSE
The water supply hose must be connected to the washing machine at one end and to the water faucet
at the other. Do not stretch the water supply hose. If the hose is too short and you do not wish to
move the water faucet, replace the hose with a longer, high-pressure hose.
Select appropriate faucet as shown in the figures below. If none of these faucets are available, use
the faucet adapter provided.
The end of faucet spout should be longer than 10mm (0.4"), or the connector cannot be fixed properly.
Water leakage could develop.
SINK FAUCET CONNECTION
For normal kitchen-sink tap only use the inlet hose with cold water inlet.
Connect the inlet hose to the male hose thread adapter by turning it clockwise to be fixed tightly.
Make sure to insert the rubber ring enclosed. Then connect tightly to your sink.
Note:
Some faucets may require you to also use the female hose thread adapter between the male
adapter and your sink faucet as shown below. Make sure the rubber ring is inserted and
connect to your sink.
If water leaks from faucet connection or washer connection, turn off water and
tighten fully using a wrench. Be careful not to over tighten and damage water
connection. Turn on water supply and make sure no leaks are present
10
.