Connecting The Water Supply Hoses / Sink Faucet Connection; Disconnecting The Water Supply Hoses / Positioning The Drain Hose - Avanti SLTW37D0W Manuel D'instructions

Ø
SINK FAUCET CONNECTION
For normal kitchen-sink tap only use the inlet hose with cold water inlet.
Connect the inlet hose to the male hose thread adapter by turning it clockwise to be fixed tightly.
Make sure to insert the rubber ring enclosed. Then connect tightly to your sink.
Note:
Some faucets may require you to also use the female hose thread adapter between the male
adapter and your sink faucet as shown below. Make sure the rubber ring is inserted and
connect to your sink.
If water leaks from faucet connection or washer connection, turn off water and
tighten fully using a wrench. Be careful not to over tighten and damage water
connection. Turn on water supply and make sure no leaks are present
Ø
DISCONNECTING THE WATER SUPPLY HOSES
Dismantling the hose directly may cause water to splash due to the possible high water pressure in
the hose, even after the faucet has been turned off. Please take off the hose as per following steps,
even if the faucet is closed:
·
Turn off the faucet.
·
Turn on the power and let the machine run for about 5 seconds then turn
it off.
·
Remove the connecting nuts from the faucet and washing machine.
Note: If the washing machine is frequently used, it is not necessary to dismantle
the inlet hose to avoid possible damage to the screws.
Ø
POSITIONING THE DRAIN HOSE
The drain hose is installed during production.
The recommended height for the drain stand pipe is 48 inches (122cm); if draining
to a laundry sink or wash basin minimum recommended height 39 inches (99 cm)
and no higher than 96 inches (244 cm).
The drain hose must be routed through the drain hose clip into the drain pipe.
The drain stand pipe must be large enough to accept the outside diameter of the
drain hose.
10
.
CONNECTING
NUT