Hoover SteamVac F5915-100 Mode D'emploi page 15

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3-21
10. For heavily soiled areas, it may
be necessary to repeat the cleaning
process. Make crisscrossing strokes
to the original pattern; overlap each
pass.
4. Maintenance
Removable
brushes
Your carpet cleaner is equipped
with removable brushes for easy
cleaning.
To remove brushes
Disconnect cleaner from electrical
outlet.
To prevent possible leaking, remove
clean solution tank and recovery
tank. Set tanks aside.
4-3
B
B
B
B
Press all four latches (B) and pull
brush block out. The brushes can
be cleaned under running water.
Make no more than 2 passes with
the solution over any one area to
prevent over-wetting and damage
to fabric.
If additional cleaning is necessary,
wait until the upholstery is complete-
ly dry before using the tool again.
11. Empty recovery tank when the
motor sound becomes higher
pitched and there is a loss in suction
(see "Automatic shut-off", page 8).
4-1
Press handle release pedal to lower
handle. Turn cleaner over so bottom
is facing up.
4-4
C
D
F
E
C
To replace brushes
Align posts (C) on both ends of
brush assembly with slots (D) in
cleaner housing.
Make sure that square post (E) also
aligns with square hole (F). Turn
brushes slightly until post fits easily
into hole.
When finished cleaning, follow "After
cleaning" instructions on pages 10
and 11 and "After using tool" instruc-
tions on pages 13 and 14.
4-2
A
B
Grasp inner portion of brush (A) and
pull brush assembly out slightly to
reveal latches (B).
4-5
D
Press brush assembly firmly to snap
into place.
B
B
Continued §
15

Publicité

Table des Matières
loading

Table des Matières