WaterLink SpinTouchDW Mode D'emploi page 5

¬ Do not touch the screen with a sharp object.
¬ Do not place objects on the screen that will scratch or damage it.
¬ Avoid touching the screen with wet fi ngers.
TESTING
1. Press and hold until the meter turns on.
2. Tap . Select a Water Source type. Tap
3. Tap . Select a disk series (found on disk packaging). Tap
NOTE: Disk Series are limited by Water Source Type selection.
4. Remove a disk from the packaging.
5. Use the syringe (1189) to fi ll the disk with the water sample.
6. Insert the disk. Cover the disk with the Universal Disk Cover. Close the lid.
7. Tap to start test. Tap
8. The results will be displayed.
9. Choose an option.
¬ Tap to return to the Test Screen.
¬ Tap the highlighted
not enabled.
¬ Tap the hightlighted
Printer.
10. Press and hold
NOTE: For water samples over 100 °F (38 °C) subtract 0.3 from pH result or, for the most accurate
result, wait until water sample is below 90 °F (32 °C) to test.
Source
CL Treated
Disk Series
DW11
30-Jan-18
12:14 AM
to cancel the test.
to save the test results to the test log if Auto Save is
to send the results to the enabled Mobile Bluetooth
for 2 seconds to turn the meter off .
Tap to
Start Test
s o
to confi rm.
5
to confi rm.