Mutsy EVO Mode D'emploi page 25

English
adjusting, press down both snap but-
tons to relock the shoulder protectors
in place.
· The back support contains three posi-
tions for the shoulder belts. To adjust
the position you remove both shoulder
belts by moving the attachment rings
through the openings in the back of the
seat. Move the attachment rings through
the desired openings so that the shoul-
der belts are positioned properly.
· Regularly check the length and position
of the belts and adjust, where necessary.
safe2go car seat (up to 13 kg)
· Make sure that the frame has fully been
unfolded and the brake blocked during
all actions indicated below.
Place the safe2go adapters on the frame
· There are two foldable attachment
points on both sides of the frame. Make
sure that the attachment points are in a
vertical position.
· The adapter marked with 'R' is placed
on the right side of the frame, the adapt-
er marked 'L' is placed on the left side.
· Slide the adapters in the attachment
parts and press solidly until you hear
a click.
Place the safe2go car seat
· Orientate the Safe2go car seat such
that it is directed rearwards on the
frame.
· Hold the Safe2go car seat with the cen-
tral hinge points of the support bar di-
rectly above the adapters.
· Lower the Safe2go car seat and press
solidly into the adapters until you hear
a click.
· Check that the Safe2go car seat has
been placed horizontally and has been
attached properly by trying to lift it
from the frame.
20
remove the safe2go car seat
· Press the buttons on both adapters to
unlock the Safe2go car seat.
· Lift the Safe2go car seat straight up
from the frame.
remove the safe2go adapters (z1)
· Pull the unlock buttons on the inside of
the adapters upwards and vertically re-
move the adapters from the attachment
points.
Maxi-cosi car seat
· The Maxi-Cosi car seat adapters are suit-
able for use with the following Maxi-Cosi
group 0+ car seats: Maxi-Cosi Pebbles,
Maxi-Cosi Cabriofix, Maxi-Cosi City.
· Always observe the instructions in the
manual of your Maxi-Cosi car seat be-
fore you start using the car seat.
· Make sure that the frame has fully been
unfolded and the brake blocked during
all actions indicated below.
Place the Maxi-cosi adapters on the frame
· There are two foldable attachment
points on both sides of the frame. Make
sure that the attachment points are in a
vertical position.
· The adapter marked with 'R' is placed
on the right side of the frame, the adapt-
er marked 'L' is placed on the left side.
· Slide the adapters in the attachment
parts and press solidly until you hear
a click.
Place the Maxi-cosi car seat on the adapters
· Orientate the Maxi-Cosi car seat such
that it is directed rearwards on the frame.
· Hold the Maxi-Cosi car seat with the
central hinge points of the support bar
directly above the adapters.
· Lower the Maxi-Cosi car seat and press
solidly into the adapters until you hear
a click.