Mutsy EVO Mode D'emploi page 24

· Push the buttons on both sides of the
push bar and turn the push bar down-
wards until it has reached its lowest
position.
· This position is indicated by means of a
marking on the hinge point.
· Pull the unlock buttons on the inside of
the frame towards you and then push
the top part of the frame downwards.
· Pull the button at the back of the seat
upwards, hold this upwards and tilt the
back support of the seat backwards un-
til it is fully flat.
· Push the buttons on both sides of the
leg support and push the leg support
fully downwards.
adjust the back support (s)
· Pull the button at the back of the seat
upwards and hold it upwards.
· The back support has 4 positions.
Place the back support in the desired
position and release the button to lock
the position.
adjust the leg support (t)
· Lift the leg support to place it upwards.
· Push the buttons on both sides of the
leg support and push the leg support
downwards to lower it.
attach and remove bumper bar (t)
· Push the ends of the bumper bar in the
thereto designated notches in the seat
until you hear a click.
· Press the unlock buttons on both sides
of the bumper bar and remove the
bumper bar from the seat.
The integrated foot step (v)
· There is a zipper around the leg sup-
port of the seat. If so desired you
can open this zipper to thus create
a higher foot rest for your child. The
child can then place the feet on the
aluminium bar of the leg support.
When your child gets bigger you can
again close the zipper and your child
can place the feet on the plastic foot
rest of the frame.
The hood (u1, u2)
· Hold the front hood bar in the centre
and move it forwards or rearwards to
adjust the hood. (u1)
· Open the zipper in the centre to further
enlarge the hood. Close the zipper to
again reduce the hood. (u2)
· Pull the flap on the front side of the
hood outwards to additionally enlarge
the hood. Push the flap inwards to
again reduce the hood.
assemble the rain cover on the seat (w)
· Make sure that the hood of the seat is
in the upright position.
· Possibly open the zipper in the rain
cover to adapt it to the enlarged hood
of the seat.
· Place the rain cover from top to bottom
over the seat and make sure that the rain
cover is attached well behind the back
support and over the leg support.
The 5-point safety harness (x, y)
· Place your child in the seat and make
sure that the legs of your child are
placed on each side of the leg piece.
· Make sure that the hip and shoulder belt
is positioned correctly over your child
and place both plastic clamps in the
central part of the harness attached to
the leg piece.
· To adjust the length of the shoulder
straps, loosen the shoulder protectors
from the belt by undoing the snap but-
tons. This will reveal the belt buckles.
Adjust the length by sliding the buck-
les along both shoulder straps until
your child is comfortably secure. After
English
19