What's In The Box; Parts List; Assembling Your Telescope; The Mount - Celestron ASTROMASTER 70AZ Mode D'emploi

WHAT'S IN THE BOX

We recommend saving your telescope box so it can be used to store the telescope when it is not in use Unpack the box
carefully as some parts are small Use the parts list below to verify that all parts and accessories are present

PARTS LIST

1
2
3
4
5
6
7
8
9

ASSEMBLING YOUR TELESCOPE

THE MOUNT

The AstroMaster AZ mount and tripod come fully assembled,
so setting it up is easy
1 . Remove the tripod and mount from the box
2 . Loosen the hand knobs at the bottom of each leg and
extend the inner section of the leg to the desired length
Tighten the knobs to secure the legs, being careful not
to over tighten
3 . Stand the tripod upright and pull the tripod legs apart
until the center brace snaps into place
4 . Place the accessory tray on top of the center brace line
up the keyed hole in the center Rotate the tray until the
tabs at the three points of the tray snap into the holders
on each arm of the tripod's center brace
6 I ENGLISH
10
1. Telescope Tube
2. StarPointer Finderscope
11
3. Eyepiece (20mm shown)
4. Erect Image Star Diagonal
12
5. Focus Knobs
6. Panning Handle/Altitude Clutch
7. Tripod
8. Accessory Tray
9. Tripod Leg Clamp
10. Objective Lens
11. Telescope Mounting Clamp
12. Azimuth Tension Knob