Installation - Piusi F0075010B Notice D'utilisation Et D'entretien

IMPORTANT! Any installation operation shall be carried out by a suitably
trained staff, following carefully the information given in this manual.
Check the packaging at the reception of the goods and store only at a dry place. Verify that
the device hasn't been damaged during transport or storage operations. Make sure you re-
ceive all the components. Ask the manufacturer for any possible missing component.
The hose reel has to be wall mounted at a minimum height of the floor of 2.50 m in or-
der to prevent accidents during work operations. Considering the hose reel weight and
dimensions, his movement requires the use of lifter devices.In particular cases it is possible
to mount it on the floor or on other machines as accessory, only if complete with a fixed sup-
port. The hose-guide arms can be fixed in three different positions according to the hose reel
installation (see pictures A-B-C p.35).
Mount the hose reel in fixed position or with revolving stand (optional) on stiff and consistent
walls using 4 dowels of 10 mm diameter. (see drawing p.35)
WARNING! The manufacturer declines any responsibility for injuries to people or da-
mages to things caused by a wrong assembly of the hose reel.
Always connect the hose reel to the line by the couplers and the flexible hose (A) su-
itable for this use, above all in case of high pressure and temperature.
To avoid consequent loss of fluid tighten the fittings using appropriate keys, keep back
the swivel joints to avoid damaging them.
According to the rules, put a ball-tap on the feeding line of the hose reels in order to make
the maintenance operations easier. The said ball-tap can be used as a safety valve for dan-
gerous situations.
9A - OIL,DIESEL FUEL AND PETROL VERSION
Fix the swivel (and the elbow, if any) on the hose reel con-
nector, using a suitable sealer. Always connect the hose reel
to the line by the couplers and the flexible hose (A) suitable
for this use.
IMPORTANT! When you lock the coupler, keep back the swivel joint
(B) by the wrench in order not to damage it.
9B - WATER/UREA VERSION
The water or urea version already features a 90° swivel and a 20
mm dia. hose-end fitting, made of white non-conductive plastic.
Tighten the swivel manually, fit the hose on the hose-end fitting
and fasten using the clamp provided. IMPORTANT: no sealants
are needed.
ATTENTION! According to the rules, put a ball-tap on the feeding
line of the hose reels in order to make the maintenance operations
easier. The said ball-tap can be used as a safety valve for dan-
gerous situations.

8 - INSTALLATION

9 - LINK
- 12 -
A
B