Hose Installation - Samoa 506 Serie Guide D'instructions Et Pièces De Rechange

MAINTENANCE AND REPAIR PROCEDURES

HOSE INSTALLATION

1. Clamp the hose reel firmly to a work bench.
2. Pre tension the hose reel power spring by rotating the spool:
10 m spring: 16 turns
15 m spring: 19 turns
15 m HD spring: 21 turns
3. Introduce the hose end to fix to the hose reel through the outlet
guide and then through the opening in the drum of the spool. Pull
the hose through the drum towards the swivel.
4. Fix the hose to the swivel as indicated in figure 8a and fix the U bolt
as shown in figure 8b.
5. Fix the hose stop to the free end of the outlet hose.
6. Pull out the hose slightly to free the spool latch and then gradually
release the hose to allow the hose reel to wind up the hose.
7. If the hose reel does not rewind satisfactorily then adjust the tension
of the power spring (see "Spring load adjustment").
WARNING: Before removing the hose, close the nearest shut
!
off valve to the reel and open the fluid control gun to release
the pressure inside the hose.
NOTE: During hose installation, tighten the U-bolt just till the hose gets
slightly deformed. Do not overtighten the U-bolt, since the hose could
be damaged.
1. Unwind the hose completely and then search for the ratchet locking
position (fig. 6).
2. Remove the hose stop (fig. 7).
3. Disconnect the hose as shown (fig. 8a). Release the hose from the
disk by removing the clamp (fig. 8b).
4. Pass the new hose through the hose outlet and connect it again to
the hose reel. Assemble the clamp and assemble the hose stop to the
required length.
5. Pull the hose hard enough to release the latch, and slowly allow the
hose to retract (fig. 9).
Fig. 8a
SPRING LOAD ADJUSTMENT
!
WARNING: Do not over tension the reel. excessive strain on the hose and reel spring could damage the reel.
To increase spring tension
1. Pull the hose out 10 feet (3 metres) and let the hose reel latch (fig. 11).
2. Wind the hanging hose into the reel (fig. 13).
3. Gently pull the hose, it will be automatically rewound (fig. 14).
4. Repeat if more spring tension is required.
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
Fig. 8b
To decrease spring tension
1. Pull the hose out 10 feet (3 metres) and let the hose reel latch (fig. 11).
2. Unwind one turn and pull the hose (fig. 12).
3. Gently pull the hose, the hose is automatically rewound (fig. 14).
4. Repeat if less spring tension is required.
Fig. 6
Fig. 7
Fig. 9
3
R. 04/18 850 812