Samoa 506 Serie Guide D'instructions Et Pièces De Rechange page 2

EN
DESCRIPTION
Open hose reel for air, water (cold or hot; high or low pressure), antifreeze, vacuum, lubricants, grease and other fluids depending on model.
Hose can be extended to the desired length and latched with the mechanism.
By pulling the hose, the latch is released and the hose is automatically rewound.
WARNING:
!
• This equipment is for professional use only.
• Do not allow the hose to recoil unattended.
• Ensure that pressure does not exceed maximum working pressure of lowest rated system component.
• Use fluids and solvents that are compatible with the equipments wetted parts.
• Release pressure inside the reel before servicing.
• The spring is always under great tension. To reduce the risk of serious injury:
- Do not attempt to remove spring.
- Do not attempt to replace or service the spring.
• Fluids under pressure can cause serious injury.
INSTALLATION
Hose reel can be installed directly onto a fixed surface or using a plate
(fig. A) or a pivoting bracket (fig. B).
For optimal operation; the hose arm guide can be mounted in these positions:
• PERPENDICULAR REELING
Recommended for ceiling and wall or column under 2.5 m (8 feet) (fig. 2).
• SIDE REELING
Recommended for wall, column, bench, tank, etc (see fig 3).
• TANGENTIAL REELING
Recommended for wall or column at a height above 2.5 m (8 feet),
mobile units, lube truck, tank assemblies, etc. (fig. 4).
Fig. A Fig. B
2
850 812 R. 04/18
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
Fig. 2
Fig. C
To reposition the hose guide arm, follow these steps:
1. Clamp the spool with c-clamp to lock the hose reel (fig. C).
2. Remove the hose stop.
3. Unscrew the fixing screws (fig. 5).
4. Place the hose guide arm in the required position and screw the
fixing screws.
5. Insert the hose reel through the hose outlet and assemble the hose stop.
Affix the hose stop.
6. Unlock the spool.
Fig. 3
Fig. 5
Fig. 4