Replacing The Lamp - AEG S64034CSX2 Notice D'utilisation

12 www.aeg.com
Problem
The compressor does not
start immediately after
pressing the COOLMATIC,
or after changing the tem-
perature.
Water flows inside the re-
frigerator.
Water flows on the floor.
Temperature cannot be set. The FROSTMATIC or
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.

6.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Possible cause
This is normal, no error has
occurred.
The water outlet is clog-
ged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
COOLMATIC function is
switched on.
The temperature regulator
is not set correctly.
The food products' temper-
ature is too high.
Many food products are
stored at the same time.
The FROSTMATIC function
is switched on.
The COOLMATIC function
is switched on.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Solution
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
Switch off FROSTMATIC or
COOLMATIC manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FROSTMATIC
or COOLMATIC function".
Set a higher/lower tempera-
ture.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Refer to "FROSTMATIC func-
tion".
Refer to "COOLMATIC func-
tion".