Tool it LCD 11 INVADER TRUE COLOR Mode D'emploi page 5

11
TRUECOLOR
The INVADER 11 mask complies with Regulation (EU) 2016/425 on personal protective equipment. This confirmity is established in compliance with EN 175, EN 166, and EN 379.
Notified bodies / organisations :
Cell :
Identification number : 1883
This welding helmet is delivered ready for use. For your protection, please read carrefully these instructions and consult with a qualified instructor prior to operation.
BEFORE WELDING
-Check that the welding helmet is in good condition and headband adjustment.
-Check whether the front cover lens, the front frame and filter are inserted and fixed in place. In case of anomalie, please proceed to its reconditionning.
-Make sure that the 2 sensors (4) and the cell (2) are not obstructed by dust or debris.
-Make sure that the protection films on both screens are removed.
-Check that the protection level matches your welding processes. Please refer to the following chart to help your choice (cf. welding process board)
OPERATION
The INVADER 11 auto-darkening welding helmet switches from light to dark state when a welding arc is struck. The auto-darkening welding helmet switches back to the light
state when the arc stops.
1
PRECAUTIONS
• The welding helmet is suitable for use with virtually all welding processes except Oxy-Acetylene welding, laser welding and gas welding.
• Standard protective screens must be installed on both inside and outside surfaces of the module. Failure to use protective screens may constitute a safety hazard or result in
irreparable damage to the module.
HEADBAND ADJUSTMENT
The INVADER 11 is equipped with a headband which can be adjsuted in multiple ways to suit the welder: width, height (1), longitudinal inclination (3) and adjustment (2).
EN
Welding hood / Protection
screen :
2
1. LCD protection plate
4
2. Solar cell
3. Filter
3
4. Sensors
Clear shade
3
Dark shade 11
Filter dimension
110 x 90 mm
Reaction speed 0,00025 s
Power supply
Li-Mn + Solar
Weight 470 g
Field of vision
100 x 49mm
Applications MMA 10>150 / TIG 10>175 / MIG-MAG 10>200 / Grind
Warranty
2 years
Application temperature -10°C / + 60°C
Storage temperature
-20°C / + 70°C
3
Identification number : 1883
1
2
5