Specification - Ametek Sorensen XEL Serie Mode D'emploi

General specifications apply for the temperature range 5°C to 40°C. Accuracy specifications
apply for the temperature range 18°C to 28°C after 1 hour warm-up with no load and calibration at
23°C. Typical specifications are determined by design and are not guaranteed.
OUTPUTS
Voltage/Current Ranges:
XEL 15-5
XEL 30-3
XEL 60-1.5
XEL 30-3D
Note: In manual operation, actual maxima for voltage and current are typically 1% greater than the
figures given above.
Voltage Setting:
Current Setting:
Configuration Selection:
(XEL 30-3D only)
Voltage Span Control
(V-Span)
Settings Lock
(S-Lock)
Output Mode:
Output Switch:
Output Terminals:
Transient Response:
Voltage Programming
Speed (XEL-P models):
15V 5A
15V 500mA
30V 3A
30V 500mA
60V 1·5A
60V 500mA
Ripple and Noise
(20MHz bandwidth):
0V to 15V/1mA to 5000mA; 0V to 15V/0.1mA to 500mA
0V to 30V/1mA to 3000mA; 0V to 30V/0.1mA to 500mA
0V to 60V/1mA to 1500mA; 0V to 60V/0.1mA to 500mA
0V to 30V/1mA to 3000mA; 0V to 30V/0.1mA to 500mA (each output);
0V to 30V/2mA to 6000mA; 0V to 30V/0.2mA to 1000mA (parallel mode).
By coarse and fine controls.
By single logarithmic control.
Independent, True parallel, Isolated Tracking & Isolated Ratio Tracking
modes via front panel rotary switch.
The voltage adjustment range can be controlled by digital setting of the
end-stop values of the coarse voltage control to any desired values.
The range for Vmax is 0.1V to 15V/30V/60V depending on model.
The range for Vmin is 0 to (Vmax – 0.1V).
Voltage and current settings can be locked by a single button press.
Lock accuracy is equal to meter accuracy (see Meter Specification)
Constant voltage or constant current with automatic cross-over.
CC indicator lit in constant current mode.
Electronic, non-isolating.
Preset voltage and current limit displayed when Output is off.
Output rise time with no load <15ms.
Universal 4mm safety binding posts on 19mm (0·75") spacing for Output;
screwless terminals for Sense.
<50µs to within 50mV of setting for a 90% load change.
Maximum time required for output to settle within 1% of its total excursion
(for resistive load). Excludes command processing time.
Full Load
Up 45ms
Up 45ms
Up 45ms
Up 45ms
Up 45ms
Up 70ms
Normal mode voltage: <0·4mVrms and 2mVp-p
Normal mode current: <0·2mArms; <40µArms on 500mA range.
Common mode current: <5µArms

Specification

No Load
40ms Down
40ms Down
40ms Down
40ms Down
40ms Down
40ms Down
Full Load No Load
6ms 100ms
60ms 100ms
20ms 150ms
50ms 150ms
50ms 300ms
110ms 300ms
5