Maintenance And Cleaning - Nahita blue 5173 Serie Mode D'emploi

C3-03: 4800 BPS
C3-04: 9600 BPS
C3-05: 19200 BPS
C3-06: 115200 BPS
3. Once selected the desired baudrate press CAL key 3 times to confirm set and
return to weighing mode.
Data format
10 bits, 0 as start bit, 1 as stop bit, 8 digits (ASCII code)
Rity bit: No.
Output data format
1 2 3
Type Space Space or *
RECOMMENDATIONS OF USE
Warming up is necessary before any operation is made to the balance.
In TARE mode, the value of the tared object cannot exceed the rated maximum
capacity of the balance.
Calibration is necessary to ensure a reliable weighing.
Switch off the balance when it is not used.
It is suggested to turn the round platter clockwise before take it off the balance.

5. MAINTENANCE AND CLEANING

To get the best results and a higher duration of the balance it is essential
to follow the processes of use.
Note: All the processes of use mentioned below will not have any value unless
you keep a continued and careful maintenance.
•
Please follow the processes of use of this manual.
•
This manual should be available for all users of this equipment.
•
Prevent the balance from sudden movements and knocks, as well as from
direct sunlight or air flows. The balance is a precision instrument, you must
handle it carefully.
•
The balance has to be plugged to an earth connection and the socket should
be handy and ready to unplug the equipment in case of emergency.
•
Never unplug the balance by pulling the wire, do it from the base.
•
Never use the balance in a wedged location as for example a shelf.
•
Never use sharp objects as pens, etc... to press the buttons of the control
panel; only use your fingers.
4 5 6 7
+ /- data data data
8 9 10
data or dot data or dot data
20
11 12 13 14
data data unit unit
15 16
End Return