Installing The Power Supply - Avaya 4000 Serie Manuel D'installation

Before You Begin
Slide the switch into the rack. Insert and tighten the rack mount screws.
Note:
The ERS 4000 Series mounting hardware is specific for each switch model. Do not mix
screws or brackets between different ERS 4000 Series switches.

Installing the power supply

You must install at least one power supply before using the switch. Some ERS 4000 Series
models can support an optional second power supply for redundancy and load sharing.
To install the power supplies into your switch, perform the following procedure.
1. Insert each power supply into a rear power supply slot. If a blanking plate covers
2. Verify that each power supply is fully seated in the slot and securely clipped in
3. Once you have installed at least one power supply, you can connect the power cord
20 Avaya Ethernet Routing Switch 4000 Series Regulatory Information
the required power supply slot, remove the plate before inserting the power
supply.
place.
to a power outlet.
Comments? infodev@avaya.com
June 2012