Assembly; Assembling The Blow Pipe And Control Handle - Poulan Pro PR48BT Manuel D'instructions

Assembling the blow pipe and
control handle
• Connect the blower and control pipe with the flexible
hose. Clamp both ends of the flexible hose in place.
Use the accompanying hardware.
1
3
1 Flexible hose
2 Control pipe
3 Clamp
4 Clamp
Note! Lubricate the pipes a little to facilitate assembly.
• Position the operating handle over the control pipe.
• Rotate the operating handle so that the notch passes
over the tabs on the control pipe.
• Align the operating handle with the key of the control
pipe.
• The cabling of the operating handle must not be
twisted during assembly.
• Adjust the position to achieve a comfortable working
position. Tighten the throttle handle clamp.
• Secure the cabling at the center of the flexible hose
using supplied clamp.
12 – English

ASSEMBLY

2
4
Blower pipe
NOTE: Make sure the screws in the pipes are moved out
of the way so they do not cause obstructions during
assembly. Assemble the intermediate pipe and the blow
pipe. Align the screws with the threaded holes in the
pipes. Tighten screw upon completing assembly of blow
pipes. It is possible to add more intermediate pipes if
longer round blower pipe are required.