Led Indicators - Axis Q60 Serie Guide D'installation

LED Indicators

LED Color
Status Unlit
Amber
Amber/red
Red
Green
Midspan LED Indicators
LED Color
Port Unlit
Green
Green, flashing
Green, flashing
AC Green
Connectors
For specifications and operating conditions, see page 13.
Network connector - RJ45 Push-pull Connector (IP66). Supports High Power over Ethernet (High
PoE). Use the supplied midspan.
NOTICE
NOTICE NOTICE
• The product shall be connected using a shielded network cable (STP). All cables connecting
the product to the midspan shall be shielded (STP) and intended for their specific use.
Make sure that the midspan is properly grounded. For information about regulatory
requirements, see Regulatory Information, on page 2.
• To comply with the IP66-rated design of the camera and maintain the IP66 protection,
the supplied RJ45 Push-pull Connector (IP66) shall be used. Alternatively, use the RJ45
IP66-rated cable with premounted connector which is available from your Axis reseller.
Do not remove the plastic network connector shield from the camera.
Indication
Connection and normal operation
Steady during startup. Flashes during firmware upgrade.
Flashes amber/red if network connection is unavailable
or lost.
Flashes red for firmware upgrade failure.
Shows steady green for 10 seconds for normal operation
after restart.
Indication
No camera connected.
Steady when camera connected, normal operation.
Slow flash when overcurrent or short circuit condition
on the port.
Fast flash when input voltage is out of range or other
internal error.
Steady when AC power input connected.
12
AXIS Q60 Series