Bodum 11533 BISTRO Mode D'emploi page 10

SETTing up
ThE AppliAncE
SpEciAl SAFETY
inFormATion
bEForE You uSE
Your SAnDWich
ToASTEr
Always place the device on a stable, level surface that is
neither hot nor anywhere near a heat source. the set-up
surface must be dry. Keep the device and its power cord out
of children's reach.
Double-check to make sure that the voltage rating on the
identification label of the device is congruent with the mains
voltage of your specific region. Plug the device only into a
properly grounded socket with an output rating of at least 6A
(if you are using a fault protection switch plate (rCD), please
ask an electrician for advice). While the device is in operation,
the socket must be easily accessible in the event of an emer-
gency. the manufacturer shall not assume any liability for
accidents resulting from deficient or non-existing grounding.
if the socket should not be compatible with the plug of your
appliance, please have the socket replaced by a certified
electrician.
Do not use any metal parts, knives, forks or similar objects
to place sandwiches into the toaster or to remove them.
this could damage the anti-stick coating. Always use plastic
or wooden spoons/tools.
An extension cord can be used with this device provided
the applicable precautions are taken.
if you are planning to use an extension cord, make sure
that the electrical indices of the extension cord are at least
the same as those of the device. if the device is grounded,
the extension cord must be three-prong and grounded.
the longer cord must be positioned in such a manner that
it does not hang down over the edge of a table or of a
work surface. Also make sure that children cannot pull on
it and that it does not create a stumbling/tripping hazard
unintentionally.
Before its first use, make sure you clean the device. See
chapter MAiNtENANCE AND CArE.
Distribute some cooking oil over the toasting surfaces. Allow
the device to heat up in setting «5» for 5 minutes while it is
empty and the cover is open. Next, turn the temperature con-
trol down to setting «i», unplug it and wait until the appliance
has cooled down.
8
EN