CC771 OPERATING MODES:
• Standard Mode (M1, M2 & M3 turned off)
•
Mode 1
(M1 lit):
Extreme mode
(10/15cc max.)
only to be used 5 times consecutively
10 minutes to cool down (showing the letters 'EA' on the display)
•
Mode 2
(M2 lit):
Extreme Mode
'Welding M1-M2-M3' button a few moments before reaching the desired vacuum)
• Mode 3 (M3 lit): Standard Mode + Soft Suction and Manual Anti-crush (press the
'Welding M1-M2-M2' button a few moments before reaching the desired vacuum)
• Mode 4 (M1-M2-M3 flashing): Dome Function to be used with Dome Accessory (sold
separately)
• Mode 5 (M1-M2-M3 lit): Marinade function to be used with external containers (sold
separately)
TURNING THE MACHINE ON / SETTING THE SEALING TIME
1. Connect the appliance to the mains power supply and switch the machine On [l]
2. Raise the lid until it locks in place – machine is now ready for use in Standard Mode
(M1, M2 & M3 off)
3. Display now shows the default Sealing Time for the Standard Mode
Note: Sealing Time is expressed in units rather than seconds, from 0.5 to 9.5 with dots
representing half a unit. E.g. on CC770 the default is '2.' ideal for the free bags supplied
4. If you want to adjust the Sealing Time, simply use the
required units are shown on the display
5. To save any changes made, press and hold the 'STOP/OK' button
new value will then flash once
Note: If you want to adjust the Sealing Time for another mode, first select that mode using the
'Welding M1-M2-M3' button and then follow steps 4 and 5 above
RESET TO DEFAULT SETTINGS
1. Switch the machine Off [O]
2. Simultaneously press and hold the 'WELDING M1-M2-M3' and
machine On [I] whilst holding the 'WELDING M1-M2-M3' and
3. The letter 'D' will be shown on the Display
for very small amount of liquid like blood residue
after which the unit locks down for
+ Soft Suction and Manual Anti-crush (press the
or
buttons until the
for 2 seconds – the
buttons and switch
buttons
UK
5