Wall Assembly - Brandson Equipment 302601 Mode D'emploi

Caution!
The carbon monoxide detector is designed only for interior use. Do not expose
the device to any moisture or rain.
The device will not warn against carbon monoxide poisoning if the batteries are
empty.
Do not open or manipulate the gas detector as this could lead to malfunctions.
7. Installation
The carbon monoxide detector is operated with 3x 1.5V AA batteries and does
not require any extra wiring. You can install the device either on the wall or place
it on a table, for example.

7.1 Wall assembly

After selecting the installation place and setting it up, ensure that no electrical
wiring or pipelines are present in this area.
Finally, mark the mounting holes and do the drilling at the marked places.
Tighten a screw in each of the two holes and ensure that the screw head projects
by approx. 4mm.
Subsequently, insert 3x1.5V AA batteries into the battery compartment of the
device and then close the compartment.
Hang up the carbon monoxide detector at the fixed screws.
Please pay attention to the chapters 6 and 6.1 about wall mounting in this user
manual.
17
English