Set-Up And Use; Before First Use; Using Your Cordless Steam Iron - Telefunken HappyCare HCASF-1 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Before first use

1. Remove any sticker, protective foil or storage cover from the soleplate.
2. Place the appliance on a flat and stable surface.
3. Put the iron on the iron rest.
4. Unwind the power cord fully, and insert the power plug into the power socket.
5. Set the thermostat button on the « MAX » position, let the iron heat up for few minutes then
start to iron on a cloth for few minutes in order for all the residue present on or under the
soleplate to go.
NOTE: It is normal that strange odor comes out from the unit for the first use. This will cease after a short
while. Some particles may come out of the soleplate when you use the iron for the first time. This is
normal; the particles are harmless and stop coming out of the iron after a short while.

Using your cordless steam iron

1. Filling the water tank
Note: Your steam iron has been designed to function using tap water. If your tap water is a very hard
water type, we advise you to mix 50% tap water with 50% of distilled water available in most shops. In
some waterfront areas, your water salt content can be high; in this case we recommend using only
demineralized water. Always check that the water tank cap is properly closed after filling it.
Never add perfume, vinegar, starch, descaling agents, chemically descaled water or other chemicals as
they may cause water spitting, brown staining, or damage to your steam iron.
2. The rechargeable base system
Your cordless steam iron is equipped with a charging base allowing you free moves during your ironing
experience by not being bothered with the power plug getting in your way. The 1
is 50 secondes and during use the charging time will be between 10 to 15 secondes. The allowing
time for ironing between each charging phase is from 20s up to 25s, please see below "Charging table"
for the operation of the base.

SET-UP AND USE

Open the water tank filler. Fill in the water tank with a jug without
exceeding the "MAX" level of water indicator then close the water
tank cap.
Always check that you have well closed back the water tank cap
before starting to use your steam iron.
Always fill in the water tank before using the steam iron.
You can always refill your water tank when in use. Just follow the
above step of water filling when the water level is low.
ENGLISH
st
time charging time
9

Publicité

Chapitres

Table des Matières
loading

Table des Matières