Turning The Concentrator On; Flowrate - Invacare Perfecto2 HomeFill IRC5PO2 Manuel D'utilisateur

6. Select the location for the humidifier bottle/adapter assembly:
•
When placing the humidifier bottle in the compartment F
on the concentrator, attach the humidifier bottle/adapter
tube to the oxygen outlet connector H on the concentrator.
•
To position the humidifier bottle in a patient side location,
place the humidifier bottle/adapter assembly in the
humidifier bottle holder I (M1521, refer to 4.1 Optional
Accessories, page 14) and place on a flat surface as close to
the patient as possible. Attach an oxygen tubing connector
(MS4301, Refer to 4.1 Optional Accessories, page 14) to
the end of the humidifier bottle/adapter tube. Connect one
end of the oxygen supply tubing G (MS4107 or MS4121,
Refer to 4.1 Optional Accessories, page 14) to the free end
of the oxygen tubing connector and the opposite end to the
oxygen outlet connector on the concentrator.
When using tubing connections longer than 2.1 m (7
feet) in length, position the humidifier as close to the
patient as possible to allow for maximum humidification
output.
7. Attach the patients' nasal cannula supply tube to the humidifier
bottle outlet.
8. After assembly, ensure that oxygen is flowing through the nasal
cannula.
1148074-F-06

6.3.2 Turning the Concentrator On

Press power switch A to On position.
1.
All the panel lights and the audible alarm will come on
for one second, indicating that the unit is functioning
properly.

6.3.3 Flowrate

WARNING!
Risk of Injury
To avoid injury from excess oxygen or a deficit of
oxygen:
– DO NOT change the L/min setting on the flowmeter
unless a change has been prescribed by your physician
or therapist.
Usage
19