Ribimex Ribitech RBAT20 Manuel D'instructions Et D'utilisation page 23

generated by various operations. The dust mask must be capable of filtrating particles generated by your
operation. Prolonged exposure to high intensity noise may cause hearing loss.
9- Keep bystanders at a safe distance away from the working area. Anyone entering the work area
must wear personal protective equipment. Fragments of work piece or of a broken accessory may fly
away and cause injury beyond immediate area of operation.
10- Hold the power tool only by the insulated gripping surfaces when performing an operation
where the cutting accessory may contact hidden wiring. The contact with a "live" wire may energise
metal parts of the power tool and create a shock hazard to the operator.
11- n.a.
12- Never lay down the power tool down until the accessory has come to a complete stop. The
accessory may grab the surface and pull the power tool out of your control.
13- Do not run the power tool while carrying it at your side. Accidental contact with the accessory
could snag your clothing, pulling the accessory into your body.
14- Regularly clean the power tool's air vents. The motor's fan will draw the dust inside the housing and
excessive accumulation of dust may cause electrical hazards.
15- Do not operate the power tool near flammable materials. Sparks could ignite these materials.
16- Do not use accessories that require liquid coolants. Using water or other liquid coolants may result
in electrocution or electric shock.
17- Release the On/Off switch and set it to the "OFF" position when the power supply is interrupted,
e. g., in case of a power failure or when the mains plug is pulled. This prevents uncontrolled restarting.
18- n.a.
19- Residual risks
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors. The following
hazards may arise in connection with the tool's construction and design:
a. Damage to lungs if an effective dust mask is not worn.
b. Damage to hearing if effective hearing protection is not worn.
c. Health defects resulting from vibration emission if the power tool is being used over longer period of
time or not adequately managed and properly maintained.
20- Noise, Vibration and Electromagnetic field information
20.1- Noise level
Wear hearing protection while operating the power tool.
The noise level has been measured in accordance with a standard test method (EN60745).
The declared noise level values are mentioned in the characteristics table.
20.2- Vibration level
The declared vibration total value has been measured in accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value may also be used in a preliminary assessment of exposure.
Warning! The vibration emission during actual use of the power tool can differ from the declared total value
depending on the ways in which the tool is used.
There is the need to identify safety measures to protect the operator that are based on an estimation of
exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the times
when the tool is switched off and when it is running idle in addition to the trigger time).
The declared vibration level values are mentioned in the characteristics table.
20.3- Electromagnetic field
Warning! This machine produces an electromagnetic field during operation. This field may under some
circumstances interfere with active or passive medical implants. To reduce the risk of serious or fatal injury,
we recommend persons with medical implants to consult their physician and the medical implant
manufacturer before operating this machine
21- Working with the tool
Only well-instructed adults should operate the product. This product is not intended for use by persons
(including children) with reduced physical, sensory or mental capabilities, or lack of experience and
Page 23 / 48