Remington XR1400 Mode D'emploi page 4

ENGLISH
C GETTING STARTED
It is recommended that you use your new shaver daily for up to four weeks to
allow time for your beard and skin to become accustomed to the new shaving
system.
, CHARGING YOUR SHAVER
• Ensure the appliance is turned off.
• Connect the adaptor to the shaver and then to the mains.
• Allow 4 hours for a full charge. The charging indicator light will indicate when
the shaver is fully charged.
• When charge is low, the top LED will illuminate a solid red light. When
charging the bottom LED will illuminate a solid green light. When fully
charged both LED's will be off.
• To preserve the life of your batteries, let them run out every 6 months then
recharge for 4 hours.
• The shaver automatically adjusts to a mains voltage between 100V and 240V.
F INSTRUCTIONS FOR USE
, SHAVING
, Note: this shaver is for cordless use only.
• Make sure your shaver is properly charged.
• Switch the shaver on by pressing the On/Off button.
• Stretch the skin with your free hand so the hairs stand upright.
• Only apply light pressure on the shaving head while shaving (pressing too
hard can damage the heads and make them vulnerable to breakage).
• Use short, circular strokes.
, SHAVING WITH SHAVING GEL
• Follow the same instructions as dry shaving if using with gel.
, Caution: After use with shaving gel, please rinse the head and cutters under
warm water to clean away any excess gel and debris.
, TRIMMING
• Push the trimmer button to release the detail trimmer.
• Hold the trimmer at right angles to the skin.
• Place the trimmer at desired trim line for a quick, easy professional trim.
• To retract and switch off the trimmer, push the trimmer down and lock into
place.
4