Bigben RRVP Mode D'emploi page 17

10.1 Storing a station to memory – as a pre-set station
• In radio mode, Press and hold
• Press (17) to start the memory. The display will flash the current station number. (e.g. P01, P02,
etc. up to P20).
• Press HR / Pre-set + or Min / Pre-set - (16, 18) to select the desired station number, e.g. P01, P02,
etc. up to P20
• Finally, press Memory [17] to confirm and save the station number
• The user can pre-set a maximum of 20 FM stations.
10.2 Returning to a pre-set station
• When radio mode is on, Press Preset + or - (16, 18) to select the desired pre-set station number, e.g.
P01, P02, etc. up to P20. The display will then show the station number (P01, P02, etc. up to P20)
and the FM frequency 3 seconds after the station is selected.
10.3 FM Scanning
• Switch to radio mode. Press
• The radio will automatically scan the frequency and save the pre-set station to memory, with a total
of up to 20 different radio stations. Once SCAN finishes scanning and stops automatically, it will
return to pre-set station no. P01. The display will show the current time and FM frequency.
• Press Preset + or Preset - (16, 18) to select the desired pre-set station number.
** When the power supply or AC power cable is reconnected, FM radio will scan the stations
automatically**
11. Insert or Replace clock back-up batteries at the bottom of the unit
• Make sure the unit is turned OFF. Insert 2 AAA batteries (not included). Check the polarity (+ and – at
ends of the battery) and follow the instructions on the diagram near the battery compartment. Close
the compartment door. The display will flash and show 0:00.
CAUTION:
Batteries must be installed by an adult.
Replace batteries when sounds play slowly or are distorted, or when the unit works erratically.
Please make sure you dispose of batteries properly (see your local regulations).
12. Basic specifications:
Output: 0.5W
FM range: 87.5 ~ 108 MHz
AC 100 - 240V ~ 50 / 60 Hz AC adaptor supplied
Battery: 2 X AAA UM4
DC only
skip - or skip + (19, 20) to search for the channel.
Scan [6] for 2 seconds to activate SCAN mode.
- FR 7 -