Krups GVE142 Mode D'emploi page 10

Masquer les pouces Voir aussi pour GVE142:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operation
Take care when handling handle
assembly as the knife is sharp.
The can-opener function
Clean the top of the can.
Connect the appliance.
Hold the appliance and lift the handle.
Position the can against the drive wheel
(2). The magnet (b2) should be in
contact with the top of the can.
Press on the handle until the appliance
starts (3). The knife automatically pierces
and opens the can.
Your can is open when it has completed
a full rotation.
Lift the handle. The appliance stops
automatically.
The top of the can is held by the magnet.
(Take care — the edge is sharp)
Recommendations :
Cans to be opened should be held by hand
as opening is completed.
When cans are damaged, it may be
necessary to make several attempts.
The knife-sharpener function
Remove the knife-sharpener from its
storage position (a).
Open the positioning aperture (e) and
latch in the accessory (4). The two slots
located on the top of the accessory allow
you to sharpen both sides of your knife.
Start the appliance by pressing the
handle (b1).
Position the knife with the side to be
sharpened downwards, and press lightly
while moving the knife along (5).
Clean the sharpening dust away with a
cloth.
Maximum use without stopping: 5
minutes.
The bottle-opener function
Close the knife-sharpener holder (e).
To remove the cap from a bottle, place
the bottle in the bottle opener (d)(6).
10
Cleaning
After use, disconnect the appliance.
Clean the motor block and the knife-
sharpener with a damp cloth.
The handle assembly (b) can be
removed during cleaning. Lift it fully and
pull it forward to remove it. This should
not be put in the dish washer.
The handle assembly can be cleaned
with a damp cloth. Dry thoroughly before
placing it back on the motor block.
Take care when handling handle
assembly as the knife is sharp.
Storage
You have the option of storing your lead
(g) and fixing your appliance to the wall (f).
To facilitate storage in a cupboard or a
drawer, you can fold down the magnet.
What to do if your appliance does
not work
Check :
the connection
that your can is correctly positioned in
relation to the appliance.
If your appliance still does not work,
contact an approved Krups service centre
(see list in the service booklet).

Publicité

Table des Matières
loading

Table des Matières