Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Connect the pump to the control box
Position the control box near to your water trough. Run the hose and lead back to the box
from the water source. Use the tie wraps to secure the lead along the length of the hose if
desired. Connect to the right two terminals (brown wire to
red terminal and blue wire to black terminal).
TIP : Position the trough so that the control box can be
placed behind a fence, protecting it from the animal.
Connect the hose to the tank
Drill the hole for the hose to tank fitting (22mm on drill bit) above your high water level. Se-
cure the hose to the fitting using the hose clip. Securely fix the tank fitting into the trough.
7
8
3
Float switch
The float switch turns off the pump as the water rises and the switch hinges upwards. Po-
sition it in a location that will be protected from animal contact, preferably in beneath the
trough service box. The switch should be positioned so that the high water level required to
turn off the pump (x) is below the incoming water pipe (y). Drill the hole at 16mm. Connect
the switch wires to the left two terminals on the front of the control box (not positive/negative
specific).
(y)
(x)
5
Publicité
Table des Matières
