Set-Up Of The Inverter For Application "C" (Transition To Full-Circle Mode); Security Feature Of The Inverter Fork - Komet Twin SR140 ULTRA Manuel Technique

Set-up of the Inverter for Application "C" (Transition to Full-Circle Mode)
1. Set Sector 1
• Set sector 1 as described in application "A", paragraph 1.
Set Sector 1 (page 10).
2. Install Full-Circle Adapter
• To ensure that after operating in sector 1 the gun will
change into full-circle operation, the full-circle adapter
must be manually installed onto the lower sector rings 2.
• Loosen the lower lock nut and move the lower sector
rings 2 towards each other, so far as to make sure
that the adapter is covering the entire gap.
• The full-circle adapter is now forming a continuous
surface preventing the screw of the lower inverter
fork to fall through the gap.
• Set the timer for sector 1 and activate it (page 14).
IMPORTANT! When the gun has changed from sector 1
to full-circle mode, the gun will continue to operate
in full-circle mode until the full-circle adapter is
manually removed.
Security Feature of the Inverter Fork
The implemented security feature of the inverter fork
should prevent damage to the sector assembly, in case of
forceful movements (for example swinging of gun during
repositioning of the irrigation machine).
ATTENTION! Has the inverter fork forcefully been moved
from its defined basic position, make sure to bring it
back to its defined position before operating the gun.
There is only one defined position for the inverter fork. In
this position the notch on the inverter fork engages with the
pin in the shaft.
• Make sure that the inverter fork in its basic position
is located in between the arrows of the sector rings 1
pointing to each other.
13