GUARDO 360 Mode D'emploi page 7

WATERDROPS & CONDENSATION
Regulary check the lens to see if waterdrops or condensation/fog have appeared as these
may be shown on your footage.
To remove/avoid waterdrops and condensation/fog, these tips might help :
• Spit or lick the port or housing lens.
• Apply a water repellent and anti-beading/ anti-fog coating or wax (such as 'RAIN-X).
• Make sure the inside of the housing and camera is as dry as possible (e.g. dry hands, no
sweat) to prevent fog/condensation.
• Don't leave the camera in the direct sun or near heat and don't leave it ON (generating
heat) when not necessary.
• Open the fogged camera housing and carefully wipe off the fog inside, then close it again.
• Try to avoid too large temperature differences as these may cause condensation/fog.
Anti-Fog inserts are optionally available on www.guardo.be.
Note: 'Muffled' sound is inevitable when using the camera with the waterproof housing.
MOUNTING THE CAMERA USING THE
DELIVERED MOUNTS
Attaching the camera to any mount, is always done in the same way:
1. Remove the screw from the mount.
2. Place the camera on the mount with the screw.
3. Rotate/Tilt the camera into the desired shooting angle and fasten with the tightening screw.
7