Remote Control Sensor - Sylvania SDVD7049 Instructions

BATTERY INSTALLATION (REMOTE CONTROL)
Battery installation:
1. Press the tab on the battery door and lift it off.
2. Install two (2) x AAA size batteries into the battery
compartment as the figure on right and the polarity
markings inside battery compartment.
3. Replace the battery door.
Battery Precautions:
Follow these precautions when using a battery in this device:
1. Use only the size and type of battery specified.
2. Besure to follow the correct polarity when installing the battery as indicated in the battery compartment.
A reversed battery may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkazline and Carbon-zinc) or old batteries with fresh ones.
4. If the batteries in the device are consumed or the device is not to be used for a long period of time, remove
the batteries to prevent damage or injury from possible battery leakage.
5. Do not try to recharge the battery not intended to be recharged; it can overheat and rupture.
manufacturer's directions).
(Follow battery
6. Do not dispose of battery in fire. Battery may explode or leak.
7. Clean the battery contacts and also those of the device prior to battery installation.

Remote Control Sensor

Remarks:
1. When there is an obstacle between the unit and
the transmitter, the transmitter may not operation.
2. When direct sunlight, an incandescent lamp,
fluorescent lamp or any other strong light shines
on the remote control of the unit, the remote
operation may be unstable.
数字签名
人 lxy
日期：
2017.09.2
3 17:28:15
+08'00'
15 feet (5m)
11
POWER