NORTH STATES Superyard Classic 8662 Mode D'emploi page 2

Thank you for purchasing our Superyard/
Petyard. Your Superyard is a second-generation
product that represents years of engineering
and product improvements, many of which
were recommended by customers such as
yourself.
Please take a few minutes to read and follow
the instructions and warning statements. In so
doing, your Superyard should provide you
with years of safe, reliable service.
Should you have any questions or concerns
regarding the installation or use of this prod-
uct, please call or write. We will be happy to
assist you in any way we can.
NOTE: Your Superyard/Petyard is a FREE
STANDING model. It is NOT designed to screw
into walls or any other solid structures.
INSTRUCTIONS
Your Superyard/Petyard is completely assem-
bled at our factory. To make an enclosure,
unsnap the carrying strap, and unfold the
panels to create a hexagon shape (figure 1).
When done unfolding the panels, the
two unconnected panels will be oriented as
shown in figure 2. Make sure that the blue
carpet "foot" is up. To connect the panels
together, lift up on panel 1 and set opening
"A" over pin "B" (figure 3). Locate the slot on
the lower end of cylinder "D". This slot tapers
to an opening that pin "C" fits into. To fit pin
"C" into this opening, gently press down on
panel 1 and align pin "C" with the end of the
slot in the cylinder "D". While maintaining
downward pressure on panel 1, lift slightly on
panel 2 and slide pin "C" along the slot and
into the opening (figure 4).
TO OPEN ENCLOSURE
To disconnect two adjoining panels, select
one of the three corners where the blue car-
pet "foot" is facing up. Gently press down on
panel 1, and while lifting up on panel 2, slide
pin "C" clear of cylinder "D". Then, lift on
panel 1 until opening "A" has cleared pin "B".
FIGURE 1
PANEL 1
PANEL 1
FIGURE 2
FIGURE 3
PANEL 2
PANEL 1
OPEN-
ING "A"
PIN "B"
FIGURE 5
PANEL 1
2
PANEL 2
D (Blue Foot)
C
B
A
FIGURE 4
PANEL 1
PIN "C"
BLUE CARPET "FOOT"
PANEL 2
PANEL 2
SLOT IN
CYLIN-
DER "D"
PANEL 2