Use And Operation - Klarstein 10032912 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

USE AND OPERATION

Starting a Wash Cycle
1. Draw out the basket. Pour in the detergent.
2. Insert the plug into the socket. . Make sure that the water supply is turned on to full pressure.
3. Press the program button , the wash program will be changed as follows direction:
Intensive > Normal > ECO > Glass > 90 min > Rapid.
4. If a program is selected, the response light will light. Then press the Start/Reset button, the dishwasher begins to
start.
Change the Programme
Premise: You can modify the washing program, When the dishwasher just runs for a short time. Otherwise, the detergent
may have already been released, and the appliance may have already drained the wash water. If this is the case, the
detergent dispenser must be refilled (see the section entitled „ Loading the Detergent „ ).
Press Start/Reset Button more than three seconds the machine will be in stand by state ,then you can change the program
to the desired cycle setting (see the section entitled „ Starting a wash cycle. . ." ).
If you open the door during washing, the machine will pause. When you close the door and press the start/reset Button,
the machine will keep on working after 10 seconds.
The program lights show the state of the dishwasher:
• One of the program lights on: stand by or pause.
• One of the program lights blinking: run.
NOTE: If you open the door when washing, the machine will pause. When you close the door , the machine will keep
on working after 10 seconds.
Add forgotten dish
A forgotten dish can be added any time before the detergent cup opens.
1. Open the door a little to stop the washing.
2. After the spray arms stop working,you can open the door completely..
3. Add forgotten dishes.
4. Close the door
5. Press the button, the dishwasher will run after 10 seconds.
At the end of the Wash Cycle
When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off the appli-
ance using the Power switch button, shut off the water supply and open the door of the dishwasher. Wait for a few minutes
before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to
43

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

10032913

Table des Matières