Operation In Detail - Klarstein Aquatica Mode D'emploi

OPERATION IN DETAIL

Starting the washing process
1 Pull out the basket.
2 Add a suitable detergent.
3 Insert the plug into the socket.
4 Press the Power button to turn on the unit.
5 Connect the inlet hose to the faucet and make sure that the water supply is set to full
pressure OR manually add the water to the tank.
6 Select the desired program. When a program is selected, the corresponding
indicator will light up.
7 Press the Start/Pause button to start the dishwasher.
Note: If you press the Start/Pause button to pause during washing, the dishwasher
will beep every minute until you press the Start/Pause button again to start.
Changing the program
If possible, a running program should be changed directly after the start. Otherwise,
the detergent may have already dissolved and run out of the machine with the water. If
this is the case, the dishwasher needs to be reset and the detergent dispenser must be
refilled. To reset the dishwasher, follow the instructions below:
1 Press the Start/Pause button to pause the washing.
2 Press Program button for more than 3 seconds, the machine will be in stand by
state.
3 Press the Program button to select the desired program.
4 Press the Start/Pause button, after 10 seconds, the dishwasher will start.
3 s
Note: If you open the door while the unit is running, the machine will stop
automatically. When you close the door again and press the Start/Pause button, the
unit will continue to move for 10 seconds.
EN
39