Replacing The Lamp; Closing The Door - AEG SFB41211AS Notice D'utilisation

28 www.aeg.com
Problem
There is too much con-
densed water on the rear
wall of the refrigerator.
Door does not open easily.
If the advice does not lead
to the desired result, call the
nearest Authorized Service
Centre.

8.2 Replacing the lamp

The appliance is equipped
with a long-life LED interior
light.
It is strongly recommended
to use original spare parts
only.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.
CAUTION!
Disconnect the plug from
the mains socket.
1. With your fingers, spread slightly
both sides of the transparent cover
to unhook them and detach the
cover pulling it in the direction of the
arrows.
Possible cause
Door was opened too fre-
quently.
Door was not closed com-
pletely.
Stored food was not wrap-
ped.
You attempted to re-open
the door immediately after
closing.
2. Replace the lamp with the one that
has identical characteristics and is
specifically designed for household
appliances.
3. Reassemble the lamp cover.
4. Connect the plug to the mains
socket.
5. Open the door.
Make sure that the light switches on.

8.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
Solution
Open the door only when
necessary.
Make sure the door is closed
completely.
Wrap food in suitable pack-
aging before storing it in the
appliance.
Wait a few seconds between
closing and re-opening of
the door.
1
2
1