Quick Start - Samson expedition XP800 Mode D'emploi

Quick Start

1. Be sure that the XP800's POWER switch is set to the OFF position.
2. If the speakers are not connected, connect the speaker wires as described in the
previous section.
3. Turn each of the channel LEVEL and MASTER volume controls fully counterclock-
wise, to the "0" position.
4. Next, connect one side of the included power cable to the XP800 mixer's power
inlet and the other to a grounded AC power outlet.
5. Connect your microphones using standard XLR cables, instruments using ¼" phone
cables, and MP3 player using
Dynamic Microphone
6. Switch on all equipment connected to the XP800, then switch the XP800's POWER
switch to the ON position.
7. Turn the MASTER level control about 3/4 of the way up.
8. Start talking or playing into channel 1 while slowly adjusting the LEVEL control
until you have reached the desired level. Do the same for each channel you are
using.
14
" cable, into the appropriate jacks on the mixer.
/
¹
8
Electric Acoustic
Guitar
Keyboard
Active
Subwoofer
XP800 Speaker Cabinets