Usb Device Operation; Aux In Function - Seg one AP123 Manuel D'utilisation

Programmed playback
You can program up to 20 tracks.
1. In STOP mode, press the PROGRAM button and the track number "P01" will
flash.
2. Press the /
3. Press the PROGRAM button to confirm.
4. Repeat steps 2 and 3 above to program other tracks.
5. To play the program, press the
6. To clear the program, press the
compartment or go to standby mode.
When programming a CD containing MP3/ WMA files, you can press the
FOLDER UP button to select the folder in which you want to program the tracks.
Insert a USB device into the USB port at the back of the unit. When the unit is
switched on, set the FUNCTION switchto select the
"CD/USB" mode. In stop mode, press the
select "USB" mode. Refer to "CD/ MP3 / WMA PLAYER
OPERATION" to play MP3/ WMA files.
Note: Due to technical differences, some models of USB storage devices or MP3
players may take longer to be read. In some cases, they may not even be
read.
USB stick should be direct connected or with a cable with max. 0.5 m length.
This unit has an AUX IN jack which allows you to connect an external audio
device (such as an MP3 player) using a cable.
1. Plug an audio cable (not supplied) into the AUX IN jack.
2. Operate your external audio device as usual to select
and play music.
3. Adjust the volume controls on both your external audio device and this unit to
the desired volume level.
Note: In AUX IN mode, this unit display cannot show any music information (e.g.
track number) for your external audio device.
buttons to select the track number.
button.

USB DEVICE OPERATION

AUX IN FUNCTION

GB-7
button twice or open/close the CD
button to