Use; Cleaning And Storage; Troubleshooting - MAXXMEE PNH-2000DI Mode D'emploi

EN

USE

Please Note!
■
Only connect the device to a plug
socket that is properly installed and
matches the technical data of the
device. The plug socket must also be
readily accessible after connection so
that the connection to the mains can
quickly be isolated.
■
If the device has any damage / faults,
switch it off immediately and pull the
mains plug out of the plug socket.
■
Never touch the radiant heater when
it is switched on. It needs to be
switched off and cooled down (ap-
prox. 15 minutes after switching off)
when the tilt angle is adjusted. There
is a danger of burns.
■
Switch off the device before going
to sleep. It must not be switched on
without supervision so that you can
intervene immediately if there are any
faults.
■
The device has a safety shutoff which
switches off the device if it topples
over.
1. Set the tilt angle of the radiant heater
before switching it on. It can be tilted
up to 45° (Picture B). If it is mounted
on the wall, do not direct it towards
the ceiling!
2. Plug the mains plug into a plug
socket.
3. Pull on the pull-cord switch (18) to
switch on the radiant heater, increase
the heat level and switch it off again.
16
05100_Inlay_A5_de-en-fr-nl_V1.indb 16 05100_Inlay_A5_de-en-fr-nl_V1.indb 16

CLEANING AND STORAGE

Please Note!
■
No liquid must get into the device.
Never immerse it in water!
■
Allow the device to cool down before
cleaning it.
■
Do not use alcohol or other caustic or
abrasive cleaners or rough sponges to
clean the device. These may damage
the surfaces.
• Regularly dust the device.
• Wipe down the device with a damp
cloth if necessary. Then dry with a soft
cloth.
• If the device is not going to be used
for a prolonged period, store it in a
cool and dry place protected from
dust out of the reach of children and
animals.

TROUBLESHOOTING

If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps below, contact
the customer service department.
Do not attempt to repair an elec-
trical device yourself!
The device does not work. It cannot
be switched on.
The mains plug is not inserted in the plug
socket correctly.
►
Correct the fit of the mains plug.
The safety shutoff has been activated
because the device is tilted too much.
►
Place the device on a stable, flat
surface.
The plug socket is defective.
►
Try another plug socket.
01.12.2020 10:25:38 01.12.2020 10:25:38