Wall Mounting - MAXXMEE PNH-2000DI Mode D'emploi

Infrared Radiant Heater
Mounting on the Supporting Leg
L
A cross-head screwdriver is
required.
Bottom rod of the supporting leg
(Picture C):
1. Place the base (12) on the ground
and plug the bottom rod (10) into the
middle of the supporting leg.
2. Twist the bottom rod so that the 4
holes in the rod plate are precisely
over the 4 associated screws (11).
3. Unscrew these screws from the sup-
porting leg. (Remove the rod to do
this.)
4. Reinsert the rod and fix it with the
screws.
5. First place the cover (13) and then a
large cable clamp (14) on the bottom
rod.
Middle rod of the supporting leg:
6. Place the middle rod (8) on the bot-
tom rod and fix it in place with the
short M 5 x 6 mm screws (9).
Top rod of the supporting leg:
7. Place the top rod (6) on the middle
rod and fix it in place with the short
M 5 x 6 mm screws (7).
8. Place a large cable clamp (15) on the
rod.
9. In the top rod you will find the tele-
scopic rod (4). If you want to extend
the height of the radiant heater, pull
the telescopic rod out as far as you
want. To do this, first loosen the lock-
ing nut (16) and tighten it again once
you have adjusted the height.
10. If necessary, place the small cable
clamp (17) on the telescopic rod.
Radiant heater:
11. Place the radiant heater on the
telescopic rod and twist the locking
screw (3) to tighten it.
12. Plug the connecting cable (5) into the
cable clamps.
05100_Inlay_A5_de-en-fr-nl_V1.indb 15 05100_Inlay_A5_de-en-fr-nl_V1.indb 15

Wall Mounting

Please Note!
■
Make sure that the surface on which
the device is mounted is stable and
that suitable screws and anchors are
used. The screws and anchors which
are supplied are designed for brick
walls. Different fixings might be re-
quired for softer surfaces. Seek advice
from a specialist retailer if in doubt.
■
Before drilling, ensure that there are
no pipes or cables behind the intend-
ed drilling point.
■
When choosing the mounting loca-
tion, bear in mind that the connecting
cable needs to reach to a plug socket
and must not touch the device or be
exposed to the heat of the device.
L
A spirit level, a drill, a cross-
head screwdriver and a pen are
required.
On the back, the radiant heater (1) has a
wall mounting bracket (2). It is hung on
the wall without the supporting leg.
1. Measure out the gaps between the
four drill holes in the wall mounting
bracket and mark them out on the
wall with a pen. Use a spirit level to
do this if possible.
2. Drill 8 mm holes for the anchors which
are supplied. With different fixings,
adjust the size of the drill holes ac-
cordingly.
3. Plug the anchors into the holes.
4. Twist the screws (M 4 x 35 mm) into the
anchors, but not all the way in. They
need to stick out a little so that the
wall mounting bracket can be hung
on.
5. Hang the wall mounting bracket on
the screws and slide it a little to the
right until it engages.
6. Lay the connecting cable (5) in such a
way that it is not touching the device.
EN
15
01.12.2020 10:25:38 01.12.2020 10:25:38