PowerWalker VI 650 SH Guide De Démarrage Rapide page 13

VI: Strong charger
 UPS is equipped with strong charger which allows recharging batteries in a very short time. Only 2-4h are
required to reach 90% capacity of the battery after complete dischage.
VII: Smal Load detection
 UPS detects even the smallest loads (for example router may require as little as 4W) and supports it with
back up power for maximum time during power failure.
Software Installation on your PC
•
Connected by USB to a PC or notebook, the Software enables communication between the UPS and
the computer. The UPS software monitors the status of the UPS, shuts down the system before the
UPS is exhausted and can remotely observe the UPS via the Network (enabling users to manage their
system more effectively). Upon AC failure or UPS battery low, UPS takes all necessary actions without
intervention from the system administrator. In addition to automatic file saving and system shut-down
functions, it can also send warning messages via pager, e-mail etc.
• install the software WinPower.
• Enter the following serial No. to install software:
• After the software is successfully installed, the communication with UPS has been established and a
green icon will appear in the system tray.
• Double-click the icon to use the monitor software (as above).
• You can schedule UPS shutdown/start-up and monitor UPS status through PC.
• Detail instructions please refer to the e-manual in the software.
Check winpower.powerwalker.com
version of monitoring software.
12
511C1-01220-0100-478DF2A
from time to time to get the latest