Connect The Es-D5B To Your Alarm System; Operating Test - eTIGER ES-D5B Manuel D'utilisation

Connect the ES-D5B to your alarm system

Switch to Connection Mode on the control panel . Press and hold the
test button on the detector for 3 seconds . The control panel beeps
once: the detector is registered . If you hear two beeps, the detector
has already been connected .
Remark
For a continual protection of your home, the detector is assigned
to the 24h zone as per default settings . In case of low battery, the
detector will beep once every 40 seconds .
The detector is working: make sure the LED blinks once every 40
seconds . If so, the detector is in normal detection mode . When the
smoke detector triggers an alarm, the alarm will not stop until the
air is smoke-free again .

Operating test

Press and hold the test button for 6 seconds . The detector beeps 3
times every second, the LED indicator blinks fast and sends a signal
to the alarm system . To make sure the detector is working properly,
it is recommend to run this test once every six months .
52 mm
106 mm
6