Zodiac Pool Systems MX6 Mode D'emploi page 4

Page 4
ENGLISH
Installation
STEP 1. Prepare the pool
1. Turn off the pool filter pump.
2. Manually vacuum the pool, and make sure the pool filter and pump basket are clean.
3. Close the pool main drain line.
4. Aim the return line fittings down.
RISK OF SUCTION ENTRAPMENT HAZARD, WHICH, IF NOT AVOIDED CAN RESULT IN SERIOUS INJURY
OR DEATH. Ensure that your vacuum suction fittings installed in your pool for connection of your suction-side
pool cleaner are certified as being compliant with applicable safety standards such as IAPMO SPS 4. Do not
block the suction fittings with any part or your body. Do not expose your hair, loose clothing, jewelry, etc. to any
suction outlet fittings or hose ends in the pool/spa.
STEP 2. Assemble hose sections
Push and twist the connector on each hose section (g) until they lock into position with clicking sound. Hose
cuffs have three (3) connection positions. Any of the three (3) positions are sufficient for an air-tight seal.
STEP 3. Connect to a dedicated suction line
1. Twist lock the male end of the hose (g) into the large end
of the extended 45° elbow (d).
2. Connect elbow to the installed Safety Vac
wall fitting (sold separately).
3. Angle the elbow toward the water surface
(Figure 3).
Zodiac MX Pool Cleaner
®
g
g
|
Owner's Manual
WARNING
Figure 2
g
d
Figure 3