Setup And Assembly; Unpacking And Cleanup; Shipping Contents - Powermatic PM2200 Instructions D'utilisation

Read and understand the
entire contents of this manual before attempting
assembly or operation. Failure to comply may
cause serious injury.

5.0 Setup and assembly

5.1 Unpacking and cleanup

Remove all contents from shipping carton and
compare to the contents list in this manual. If
shipping damage or any part shortages are
identified, contact your distributor. Do not discard
carton or packing material until dust collector is
assembled and running satisfactorily.

5.2 Shipping contents

Box #1 (Figure 1)
1 Main housing assembly – A
1 Base – B
1 Upper drum – C
1 Lower drum – D
1 Drum lid – E
1 Inlet adaptor – F
1 Hose – J
2 Hose clamps – K
1 Cone – L
1 Drum handle – N
1 Cone clamp – P
2 Fixed casters – Q
2 Swivel casters – R
4 Drum casters – S
1 Polyethylene drum collection bag – U
2 Hoses 2in. – V
4 Hose clamps 2.5in. – W
1 Drum clamp – X
2 Hose hangers – Y
2 Rolls foam tape, 1x38L in. (30x970mm) – FT138
2 Quick connectors – QC
1 Roll foam tape, 1x25L in. (30x635mm) – FT125
Box #2 (Figure 2)
1 Support frame – SF
1 Quick-release handle – G
1 Right panel – H
1 Left panel with neg. pressure gauge – I
1 Remote controller with batteries – RC
Box #3 (Figure 2)
1 Canister filter assembly – CF
1 Bag clamp – M
1 Polyethylene canister collection bag – T
1 Roll foam tape, 3/4x50L in. (20x1265mm) –
FT3/4
Hardware package (Figure 3)
36 Hex flange hd screw, 5/16x1/2 – HP1
4 Phillips pan hd screw, #10-24x3/8 – HP2
2 Phillips pan hd screw, 1/4x1/2 – HP3
8 Hex flange hd screw, 5/16x3/4 – HP4
8 Phillips pan hd screw, M5x8 – HP5
1 Open end wrench, 10/12mm – HP6
Figure 1: box #1 contents (not to scale)
Figure 2: box #2 and #3 contents
Figure 3: # PM2200-HP hardware package
contents (not to scale)
7