Safety Key; Remote Controller; Dust Hose Connection; Filter Auto Clean - Powermatic PM2200 Instructions D'utilisation

Figure 16

7.2 Safety Key

The start/stop switch comes equipped with a
magnetic safety key. See Figure 16. When in place
on the switch, the magnetic safety key trips a relay
which allows the machine to start and stop when the
respective switches are pressed. Being magnetic,
the safety key can be removed to make the machine
inoperable.
When using the machine, place the key on the
switch cover lining up the arrow on the key with the
REMOVE arrow on the cover. Then rotate the key
so the arrow lines up with the LOCK arrow. This
prevents the safety key from vibrating loose when
the machine is operating.

7.3 Remote controller

The RF (radio frequency) remote controller operates
on 2 AAA batteries (included). The batteries will
need replacing periodically. The remote controller
has an effective range up to approximately 50 feet
(15 meters).
Press the + or – button to select desired timer
setting: 2, 4, 6 or 8 hours. The dust collector will stop
automatically at end of selected period. For
continuous operation (no timer) select infinity (
position.
Figure 17
7.3.1 Remote controller reset
If the remote controller
improperly, it should be cleared and reset.
To clear the remote controller, press and hold reset
button (Figure 18) for 3 seconds until receiver
"beeps" 3 times.
4
)
begins to function
12
To reset the controller:
1. Press reset button for 1 second until receiver
"beeps" once.
2. Press and hold "ON" button on the remote
controller until receiver "beeps" twice. (If you
are using multiple remotes, perform step 2 on
each remote before proceeding.)
3. Press and hold reset button (C) for 3 seconds
until receiver "beeps" 3 times.
The remote controller is now ready.
Figure 18

7.4 Dust hose connection

Use proper type hose to connect dust collector to
machine(s) being operated. Dryer vent hose is not
acceptable for this purpose. Secure hose at both
ends with proper clamps.
If an inlet port is not being used, it should remain
capped. An open port will diminish the machine's
efficiency, and may create a safety hazard.
Contact your nearest Powermatic distributor for a
line of Dust Collector hoses and accessories. You
can customize your
maximum performance with dust hoods, hoses,
clamps, fittings, and blast gates.

7.5 Filter auto clean

Canister filter cleaning is automatic. When the dust
collector is shut off, the cleaning baffles will rotate
one direction for 5 seconds, then the opposite
direction for 5 seconds.
installation and obtain